Metal detectors for routine maintenance
4.1, routine maintenance
Daily check items
Check the following before the former (1) Jobs Jobs.
? Whether the contact area
? Confirm detection sensitivity
Qualified confirm the transfer, it is determined that [OK], and then transferred nonconforming
(2) After completion of the cleaning
Remove the belt, sweeping both sides of the conveyor belt.
Weekly inspection items
Weekly check the following: Remove the belt, check whether the end surface cracking.
Conveyor operating condition, the same sound, no creeping phenomenon.
4.2, sweeping Notes
? Must unplug it when cleaning.
? Brush with a soft plastic or cloth like cleaning tool. Do not use a metal brush.
? Use a mild detergent to clean. Do not use organic solvents such as thinner and benzene.
About stainless steel maintenance
Mild steel and stainless steel compared to aluminum, has good corrosion resistance, it is difficult to rusty metal. But not without rusty metal. Because use conditions and the impact on the environment will be contaminated and rust.
Variety of causes contamination and rusty steel, but basically by iron floating in the atmosphere and harmful gas components adhesion, accumulation or adhesion caused by salinity. Adhesive material to become the main reason for these rusty after solidification encounter moisture, does not damage the stainless steel surface dynamic film, which impede the regeneration of the state is called the state of stainless steel to rust. Since these stainless steel is in its early stages, can be removed relatively simple, back to the original surface condition. This is the layer of rust stainless steel material, not the material itself generated rust corrosion. In short, sometimes stainless steel will rust, but as long as the usual attention to maintenance, will be able to permanently maintain the original appearance of stainless steel.
Repair method
Rust caused by iron or salt can be moistened with a mild detergent or soap and water containing a sponge or cloth to wipe easily removed. Shallow water thoroughly rinsed after use, do not let the washing liquid remaining in the apparatus. Rust from cleaning agents adhesion caused can not be removed when using neutral detergent, please use cleaning agents. Due to touch and fingerprint contamination, when with a neutral detergent and soap can not be completely removed, available containing organic solvents (alcohol, gasoline, acetone, etc.) sponge or cloth to wipe.
4.3 Method handling conveyors
Conveyor belt portion detachable. In order to clean the back and conveyor pallet conveyor belt press to the order to remove it.
? Loosen four screws outside of the body.
? The belt conveyor device lifted up the side of the driven shaft, the motor drive belt to relax.
? The drive belt (belt) is released from the motor pulley.
? After disengaging the drive belt conveyor belt device lifted up from the chassis.
? The belt conveyor device removed from the side of the probe, remove the process, pay attention to the bad touch probe hole resin layer.